Front Valence

Now that the A-posts are in place, we can go about fixing the lower front valence into position. This has the holes cut out for the front bumper irons to go through.

We have modified the lower valence where the holes are for the bumper irons. The panel comes with perfectly oblong slots with 90-degree corners. The original slots were rounded on the corners and the slot was not perfectly level with the top of the panel, but lower down, so we've re-made the slots by welding up the incorrectly cut hole and dropping in the new slot cut from an original lower valence.

The correct shaped slot now showing in the lower valence (yes, we know you'll hardly see it once the bumper is on but......)