Here we go:
The Front badge gets fitted first. Some little rubber pads were made to go behind the fixing screws so we don't damage or scratch the paint:
The rear window glass and seal was fitted next. Click here to buy your window seals!
We only use and supply the very best German made seals with all moulded corners - it was less than 4 minutes to fit this! You can't see the large SEKURIT logo on the glass in this pic, but check it out when you see the van at a show!
We only use and supply the very best German made seals with all moulded corners - it was less than 4 minutes to fit this! You can't see the large SEKURIT logo on the glass in this pic, but check it out when you see the van at a show!
The rear lights and reflectors got fitted next along with the number plate light, unit and trim and the central brake light. Note the barndoor had the orange brake light and large number plate light upto chassis number 20-41711. After this, it went to the red lens and the smaller type number plate lens:
The front bumper, front number plate and headlights went in next
We supply a range of bumper parts and headlight parts - click the relevant words to access our shop!
Next we had a trial fit of the speedo dash pod and the passenger grab handle:
We then turned our attention to the rear of the van again and the engine firewall seal went in - very easy to fit whilst the engine is out!!! Click here to buy yours! Suit all model years of split van!
Next we tackle the gearbox being fitted. Check out the next post coming soon!
No comments:
Post a Comment